Roper Range FGP305K User Guide

®
30" Freestanding Gas Range  
PRODUCT MODEL NUMBERS  
OVERALL DIMENSIONS  
FGP305K  
Gas supply: Use 3/4" rigid pipe gas supply line  
to the range location. A smaller size pipe on long  
runs may result in insufficient gas supply. With  
L.P. gas, piping or tubing size can be 1/2"  
minimum. If local codes permit, it is  
recommended that new flexible metal tubing,  
design-certified by AGA or CSA, 1/2-inch or  
3/4-inch I.D., be used for connecting the range to  
the rigid gas supply line. A 1/2" male pipe thread is  
needed for connection to pressure regulator  
female pipe threads. An individual manual shutoff  
valve must be located in the same room, but  
external to the range.  
26-3/4" depth  
with handle  
36"  
cooktop  
height  
46-1/4"  
Electrical: A 120-volt, 60-Hz, AC-only,  
overall height for  
tall backguard  
models  
10-ampere, electrical supply fused on both sides  
of the line. A separate circuit is recommended. A  
time-delay fuse or circuit breaker is recommended.  
24-1/4"  
29-7/8" width  
CABINET OPENING DIMENSIONS  
13" max. upper  
cabinet depth  
30" min. cabinet  
opening width  
For minimum  
clearance to top of  
cooktop, see Note.***  
30-1/8"  
opening  
width  
18" min.  
clearance  
upper  
cabinet to  
countertop  
2" min. countertop  
space to side wall or  
other combustible  
material  
This shaded area  
Do Not seal the range to  
recommended  
for installation  
of gas pipe.  
the side cabinets.  
If cabinet depth is greater  
than 24", oven frame  
must extend beyond  
cabinet fronts by 1/2"  
min.  
This shaded area  
recommended for  
electrical outlet.  
10"  
5"  
24"  
Contact a qualified floor covering  
installer to check that the floor  
covering can withstand at least  
200°F.  
8"  
2"  
Use an insulated pad or 1/4"  
plywood under range if installing  
range over carpeting.  
*** Note: 24" min. when bottom of wood or metal cabinet is  
protected by not less than 1/4" flame retardant millboard covered  
with not less than No. 28 MSG sheet steel, 0.015"stainless steel,  
0.024" aluminum or 0.020" copper.  
5"  
3"  
30" min. clearance between the top of the cooking platform and  
the bottom of an unprotected wood or metal cabinet.  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. 98014964  
02-25-04  
 

QSC Audio Speaker I 82H User Guide
Radica Games Chainsaw 72003 User Guide
Radio Shack Speaker System 40 1441 User Guide
Renesas Power Supply RD74LVC14B User Guide
Renesas Switch M30850T2 EPB User Guide
Samsung Bluetooth Headset BHM3300NWACSTA User Guide
Samsung Flat Panel Television 320P User Guide
SBC comm Telephone SBC 116 User Guide
Schneider Electric Network Router LUFP9 User Guide
Senco Air Compressor PC1001 User Guide